Octal Density Grid Test System
The fixture tester LM800 is the test solution for big quantities for HDI products. The system can be equipped with the optical alignment system SNIPER to compensate product offsets.
KEY FEATURES
- Extra high density
- Accuracy
- Economical Efficiency
- Automatical Optical Alignment
- Low Ohm Testing
- High throughput universal fixture test System with octal (35 mil) test point density
- Test area up to 244mm x 325mm (9.6″ x 12.8″)
- Optical alignment system SNIPER optional
MACHINE FEATURES
TEST FIELD SIZE
Maximum (X x Y): 244mm x 325mm (9.6" x12.8') - Smaller field sizes available upon request
BOARD HANDLING
- Maximum board size: 284mm x 365mm (11.2” x 14.4”)
- Minimum board size: 50mm x 50mm (1.97” x 1.97”)
- Minimum board thickness:
- Manual testing 0.1mm ( 0.0039”)
- Automatic testing 0.6mm (0.023”) and warpage < 10mm
- Maximum board thickness: 8mm (0.315”)
TEST POINTS
- 35 mil (800 test points / inch²)
- 98,304 one side
- 196,608 both sides
TEST PARAMETERS
- Isolation test voltage (optional, depending on test method):
- 35V to 250VDC
- 15 V to 250VDC
- Isolation threshold: 100 kΩ to 100 MΩ
- Continuity threshold :10Ω to 10 kΩ
- Embedded resistor measurement: 1Ω to 10kΩ
GENERAL CONNECTIONS
- Data input format: IPC-D-356A
- Network connection: Ethernet, TCP/IP
- Power Supply: AC 400 V [3 / N / PE AC 400 V] 50 / 60Hz
- Compressed air: connecting preassure 6 bar
- Temperature: 20°C to 25°C
- Relative humidity: 40% to 60%
- Machine weight: about 1000kg
DATA PREPERATION
- External generation of drill-files, test-files and object files for fault location is done in ADAM II
- Required data formats for data preparation: Gerber Extended Gerber IPC-D-356A .dpf-data ODB++ Mask & drill data
- Fault location and verification is done in CAR II or on an atg flying prober
OPTIONS
- Retractable guide rails
- 4-wire measurement 10mΩ to 100Ω
- Board thickness control
- PCB offset detection module SNIPER including feedback frames
RELATED PRODUCTS
All information subject to change without notice!
For more information, visit the website or send us your information request.