FOR THIN MATERIAL
WITH ULTRASONIC MODULE AND 100 BAR WASHING
Stainless steel construction
Stainless steel construction
TECHNICAL DATA
- Working width : 640 mm
- Working height : 900 mm
- Operative conveyor speed : 2 m/min
- Min board thickness : 0,1 mm
- Max board thickness : 3,2 mm
- Min board sizes : L. 200 x W. 250 mm
- Min/max board sizes : L. infinite X W. 640 mm
- Ultrasonic cleaning
- High pressure water : 100 bar (2 Cat pumps)
- Power supply : 400 Volt 3phase – 50 Hz
- Control cabinet : separate
LINE EQUIPPED WITH :
- Entering three position board alternator
- Automatic thickness control for brushes and back up rollers
- Special transport system for thin material treatment (PATENT PENDING)
- N. 4 counter-rollers, s.s. core covered with ceramic (for thin material)
- N. 4 brushes (2 upper + 2 lower) Ø 125 mm
- Ultrasonic cleaning
- High pressure water section at 100 bar with 2 CAT pumps – 30 l/min each (7,5 Hp motor for 50 Hz supply or 10 Hp motor for 60 Hz supply)
- Drying module consisting of 1 couple of air jet blowers fed by 1 turbine (5 HP) placed inside a wheeled sound-proof box.
- Transport rollers Ø 40 mm
- N. 4 frequency controllers for precise speed adjustment of the brushes
- N. 6 frequency controllers for automatic adjustment of brushes and counter-rollers
- N. 2 frequency controllers for adequate speed adjustment of the turbines in the drying section
- Omron PLC including a touch-screen (11” graphic type)
- Automatic brush wearing compensation
- Automatic dressing and foot-print cycles
- Auto-zeroing cycle for resetting precisely the reference position of brushes and counter-rollers
- Economy system for water and power saving
- Pre-set programmes are available to reduce the setting time by the operator
- Separate control cabinet complete with connecting cables 5 m long (10 m. on request)
OPTIONS
- centrifugal copper filter with additional s.s. tank and pump
- exit centering device