This Hand tool is designed for filling of through holes in Printed Circuit Boards.
Function: The paste is stored inside this tool and is pressed through the holes of the PCB’s with compressed air, which is controlled by a foot switch. You simply control the compressed air as you slowly fill the holes. This is a “one step” process and there is no risk of getting air bubbles inside the holes. When you are finished, the Power Squeegee PS 100 is stored in the refrigerator.
The inks for this process are:
Silver Paste (Conductive)
Copper Paste (Conductive)
Epoxy Fill (Non-conductived)
System Data:
Length:
approx. 4.3”
Diameter:
2.56”
Weight:
approx. 2.5 lbs (including Paste)
Paste Capacity:
200g ( Silver Paste)
Material:
Stainless Steel
Advantages:
Partial Plugging of Holes
No more waste from the very valuable Silver Paste
No clean up or change from the paste to storage containers
Using of up to 100 lbs pressure to push the paste through very high aspect ratio (1:30) boards
No direct contact between the compressed air and the paste
The result: Surfaces ground with Plane Raze Device SV 100
E-mail us
