  |
|
| - Antares |
|
| - HC 8 Holechecker |
|
|
| - KLG SpeedStar 1&2 |
|
|
| - Visionstar |
|
|
|
|
|
|
|
|
| |
Adeon Technologies BV
Weidehek 26
4824AS Breda
The Netherlands
Phone: +31 (0)76-5410008
Fax: +31 (0)76-5425059
 E-mail us
|
|
|
|
|
|
|
 |
|
 |
|
|
|
| |
   |
|
|
 |
|
| |
 X-Ray drilling and inspection Machine Antares 700X
Antares 700 X is a machine to drill reference holes on multilayer panels. Typically the reference holes are used to inset pins, which will be used to clamp the panel with the right alignment to the X, Y axes of the drilling machine. To this aim, the reference holes must be executed with best optimization respect to the inner lay-up of the multi-layer panel. The process to drill reference holes is made in two steps: in the first step the machine will detect the centers of those targets that have been chosen to represent the internal lay-up. The enlargement/shrinking, due to the previous pressing process, as well as the registration errors are considered. In the second step the programmed holes will be executed in optimized positions based on the detected topography, but at a definite reciprocal distance, as required for pins. The drilling is performed by a pneumatic spindle using a standard drilling tool with ring. The rotation speed is fixed at 30.000 rpm. The panel is clamped by vacuum area at the center of table. The table is made by a material that is X-Ray transparent and offers the possibility of inspecting any kind of panels or PCB’s in any point, including the vacuum area, which is also X-ray transparent. The software offers a very friendly and self explaining interface toward the operator.
Max axes speed 60 m/min
X / Y strokes 800 / 900 mm, Z-axis motion system Pneumatic
Spindle speed 30.000 rpm
Cycle time 15 s 2 targets + 3 holes
dimensions L = 1535 x B = 1520 x H = 1400mm, wight 800kg
Antares.pdf (pdf, 668 KB)
|
|
|
|
|
 |
|
 |
|
|
